Panduit LCA4-38-L Käyttöohje

Panduit Kompressori LCA4-38-L

Lue alta 📖 käyttöohje suomeksi merkille Panduit LCA4-38-L (3 sivua) kategoriassa Kompressori. Tämä opas oli hyödyllinen 26 henkilölle ja sai 4.4 tähden keskimäärin 13.5 käyttäjältä

Sivu 1/3
COPPER COMPRESSION CONNECTORS
For Technical Support: panduit.comtechsupport@
Page 1 of 4
INSTALLATION INSTRUCTIONS T-PMPI-63-PC
C
Panduit Corp. 2024
Rev 1 1
1. Use a connector marked for the wire size and wire material to be used. NEVER
use a copper connector on aluminum wire.
Strip wire insulation to approximate length shown on tool chart. DO NOT nick
or
ring the conductor strands.
Clean the wire.
Insert stripped wire into connector until the wire stops.
Using installation tooling shown on other side, insert connector in die and crimp
between color bands or knurl markings, use these markings as a guide to evenly
space crimps on barrel of connector. Begin crimping near the tongue end of
the lug and continue crimping toward the wire end.
IMAGES BELOW DEPICT CRIMP ZONES, AND SERVE AS GENERAL GUIDELINES FORA
THE CRIMP AREA. REQUIRED NUMBER OF COMPRESSIONS SHOWN ON TOOL
CHART IN ( ) ON PAGES 2,3 & 4 BASED ON TOOL AND DIE COMBINATION USED.
6.
After crimping, inspect for sharp edges, flash or burrs and remove if present.
COPPER COMPRESSION CONNECTOR INSTALLATION
1
1 2
1 2 3
1 2 3 4
# ZONESOF CRIMP : 1
# ZONESOF CRIMP : 2
# ZONESOF CRIMP : 3
# ZONESOF CRIMP : 4

Tuotetiedot

Merkki: Panduit
Kategoria: Kompressori
Malli: LCA4-38-L

Tarvitsetko apua?

Jos tarvitset apua merkille Panduit LCA4-38-L esitä kysymys alla ja muut käyttäjät vastaavat sinulle