GE JX1530SMSS Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille GE JX1530SMSS (8 sivua) kategoriassa Magnetron. Tämä opas oli hyödyllinen 41 henkilölle ja sai 4.9 tähden keskimäärin 5 käyttäjältä

PARTS INCLUDED

NOTE:This kit has extra screws to prevent the technician

from spending extra time locating a replacement screw

during installation.

PARTQUANTITY

❒ Trim Frame1

❒ Bottom Duct1

❒ Top Bracket1

❒ Bottom Bracket1

❒ Upper Duct1

❒ Rear Duct1

❒ 4 mm x 14 mm22 required

Round-Head 2 extra

Screws

❒ 4 mm x 14 mm4 required

Flat-Head 2 extra

Screws

❒ Anti-Tip Brace 1

❒ Anti-Tip Bracket 1

❒ Template1

READ CAREFULLY.

KEEP THESE INSTRUCTIONS.

Installation

Built-In Trim Kits

Instructions

JX1527 JX1530

1

❒

BEFORE YOU BEGIN

Read these instructions completely and carefully.

•

IMPORTANT —Save these instructions

for local inspector’s use.

•

IMPORTANT —Observe all governing codes

and ordinances.

•Note to Installer – Be sure to leave these instructions

with the Consumer.

•Note to Consumer – Keep these instructions for future

reference.

•Skill level – Installation of this appliance requires basic

mechanical and electrical skills.

•Completion time – 1 to 3 hours

•Proper installation is the responsibility of the installer.

•Product failure due to improper installation is not covered

under the Warranty.

•This kit is UL/CSA listed for installation alone or over any

GE/GE Profile single electric wall oven. Not for use adjacent

to (within 2 feet of) any gas or electric range, cooktop

or oven.

•For easier installation and personal safety, we

recommend that two people install this microwave oven.

•Unplug the microwave oven before attempting installation

of this kit.

•This kit is for use on models: PEB1590DMBB,

PEB1590DMWW, PEB1590SMSS, PEB159CDNBB,

PEB159CSNSS and PEB159CDNWW.

•Do not alter or modify any part of this kit or the oven.

WARNING —This oven must be plugged into a

properly grounded 3-hole, 120V receptacle as required by

the National Electrical Code or Canadian Electrical Code.

FOR YOUR SAFETY:

WARNING —Before beginning the installation,

switch power off at service panel and lock the service

disconnecting means to prevent power from being switched

on accidentally. When the service disconnecting means

cannot be locked, securely fasten a prominent warning

device, such as a tag, to the service panel.

Questions? In the U.S., call 800.GE.CARES (800.432.2737) or Visit our Website at:ge.com.

In Canada, call 1.800.561.3344 or Visit our Website at:GEAppliances.ca.

Tuotetiedot