GE JX1830SB Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille GE JX1830SB (4 sivua) kategoriassa Magnetron. Tämä opas oli hyödyllinen 52 henkilölle ja sai 5.0 tähden keskimäärin 9 käyttäjältä

PARTQUANTITY

Trim Frame1

Bottom Duct1

Side Duct1

1” Screws6

(4 required, 2 extra)

1/2” Screws 15

(11 required, 4 extra)

Anti-Tip Bracket 1

Bottom Bracket 1

Upper Duct 1

Template1

PARTS INCLUDED

Questions? Call GE Answer Center at 800.626.2000

orVisit our Website at:

www.GEAppliances.com

READ CAREFULLY.

KEEP THESE INSTRUCTIONS

.

Installation Built-In Trim Kits

Instructions

JX1827 and JX1830

Read these instructions completely and carefully.

•

IMPORTANT

–

Save these

instructions for local inspector’s use.

•

IMPORTANT

–

Observe all

governing codes and ordinances.

•Note to Installer

–

Be sure to leave these

instructions with the Consumer.

•Note to Consumer

–

Keep these

instructions for future reference.

BEFORE YOU BEGIN

• Unplug the microwave oven before attempting

installation of this kit.

• Skill level–Installation of this appliance requires basic

mechanical and electrical skills.

• Completion time– 1-3 hours

• Proper installation is the responsibility of the installer.

• Product failure due to improper installation is not

covered under the Warranty.

• This kit is UL listed for installation alone or over any

General Electric/Hotpoint/RCA single electric wall

oven.

TOOLS YOU WILL NEED

Phillips screwdriver

Pencil

Tape measure

Awl or punch

Drill with

7

⁄64″bit or #35

1

FOR YOURSAFETY:

WARNING

–

Before beginning the

installation, switch power off at service panel and lock

the service disconnecting means to prevent power

from being switched on accidentally. When the service

disconnecting means cannot be locked, securely fasten

a prominent warning device, such as a tag, to the

service panel.

Tuotetiedot