Soundsphere SS-BCM Käyttöohje

Sivut 1 Englanti Ei luokiteltu

Lue käyttöohje merkille Soundsphere SS-BCM ilmaiseksi verkossa tai lataa PDF. Ohjetta on katsottu 27 kertaa. Kysyttävää mallista? Esitä kysymys

SS-BCM - Universal Beam Clamp

OWNER’S MANUAL

360º of the Best Sound Around™

Contact: MSE Audio, 855.663.5600 / 913.663.5600 / sales@mseaudio.com

BCM Installation and Safety Procedures

WARNING

Be sure to securely tighten all hardware before hanging the loudspeaker. Wire rope (steel cable), cable clamps with

saddles and thimbles of suitable size and strength are the recommended materials for overhead suspensions. All

loudspeakers should be redudantly safety wired to structural members of the building with an approved safety wire

system or other agency certied materials.

IMPORTANT: Always check local safety codes before installing any overhead loudspeaker system and for periodic

inspection and maintenance of the installation.

Install Instructions

1. Slide the BCM onto the I-beam until it stops against the I-beam ange.

2. Tighten the clamp lock bolts securely so that the tips bite into the beam. Then tighten the jam nuts down against the clamps.

3. With heavy pliers or a hammer, bend the security strap tightly around the I-beam ange as shown.

4. Hang the loudspeaker from the eyebolt (4) with supplied (or appropriate*) hardware. Be sure the BCM is in proper

alignment with the load so that the hanging weight is vertical with respect to the BCM (offset loads signicantly reduce the

load capacity of the BCM assembly).

5. Install an appropriate safety wire through the reector leg or mounting tab (located on the rear of the loudspeaker’s

reector under the leg mounting bolt) and fasten it to a suitable structural member of the building. Safety wiring standard

vary in different localities - please read the WARNING below.

CLAMP LOCK BOLTS

CLAMP JAM NUTS

Arvostele tämä ohje

Tuotetiedot

Jos tarvitset apua merkille Soundsphere SS-BCM esitä kysymys alla ja muut käyttäjät vastaavat sinulle