Soundsphere SS-BCL Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille Soundsphere SS-BCL (1 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 12 henkilölle ja sai 4.1 tähden keskimäärin 6.5 käyttäjältä

Sivu 1/1
FLANGE CLAMP
Installation Guidelines
Rev 10.22.2019
Install Instructions
Please read this Installation Guide and the attached manufacturer’s Installation Instructions carefully.
These guidelines apply to the following product only: CADDY
®
, Flange Clamp, model 4-H-2-4 (4H24).
Follow the manufacturer’s installation instructions for proper installation techniques and use of this product (see page 2).
or 3.17 - 6.35mm).
The Maximum Static Load (MSL limit) is 200 pounds (90.9 kg). The MSL applies to the clamp only - all other fasteners must
meet or exceed that weight load rating.
Never exceed the Safety Factor Limits of this product. Always allow a load safety factor based on local, state, and/or
Federal codes and regulations
The clamps are designed for axial loads only (see page 2 illustrations). Lateral or side loading must be avoided.
Ensure the clamps are installed properly. They must not be forced onto a ange that is too thick (more than 1/4, 0.250” or
6.35mm). They must not be used on a ange that is too thin (1/8”, 0.125or 3.17mm). Measure the ange if in doubt of its
thickness.
Always visually inspect clamp installation. Check to ensure that the clamp is installed square with the ange. Check to
ensure that the clamp is secure after installation.
Never strike the clamp with a hammer or other metallic device.
These clamps are designed for indoor use in non-corrosive environments only.

Tuotetiedot

Merkki: Soundsphere
Kategoria: Ei luokiteltu
Malli: SS-BCL

Tarvitsetko apua?

Jos tarvitset apua merkille Soundsphere SS-BCL esitä kysymys alla ja muut käyttäjät vastaavat sinulle