Metra 99-5802 Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille Metra 99-5802 (2 sivua) kategoriassa Autosarja. Tämä opas oli hyödyllinen 50 henkilölle.

1

FORD Expedition 1997-00 / F-150 1997-00

2

Cut and remove the Mounting Bracket

("A").Skip to the Installation Instructions for

ALL VEHICLES on Page #2.

1 2

Disconnect the negative battery terminal to

prevent an accidental short circuit. Place

your index fingers on the inner edges of the

a/c vents (shown above) and push inward.

Grasp the exposed lip of each vent opening

and pull out on the radio trim bezel. Remove

the dash trim bezel. (The airbag wiring does

NOT need to be disconnected). Using

Metra's 86-5618, pull the factory head unit

from the dash and disconnect the wiring.

Disconnect the negative battery terminal to

prevent an accidental short circuit. Using Metra's

86-5618, pull the factory head unit from the dash

and disconnect the wiring.

1

FORD Crown Victoria 1995-00 / Econoline 1997-00

Explorer 1995-00 / F-250 1999-00 / F-350 1999-00

F-550 1999-00 / Ranger 1995-00 / Windstar 1999-00

LINCOLN Continental 1995-97 / MAZDA B-Series Pickup 1995-00

MERCURY Grand Marquis 1995-00 / Mountaineer 1997-00

Cut and remove the Mounting Bracket

("A") and the bottom mounting legs

("B")from the Radio Housing. Skip to

the Installation Intructions for ALL

VEHICLES on Page #2.

2

3

4

ALL VEHICLES

"B"

CROWN VICTORIA, GRAND MARQUIS: Skip to step #5.

CONTINENTAL, ECONOLINE, F-150, MOUNTAINEER: Skip to step #4.

B-SERIES PICKUP, EXPEDITION, EXPLORER, F-150, F-250, F-350, F-550, RANGER,

WINDSTAR: Metra recommends installing the kit with the pocket at the However, to top.

install the kit with the pocket at the locate the slots on tabs bottom, "A".Using the slots as a

guide, cut and remove the portions of the tabs. shaded(see Fig. A)

B-SERIES PICKUP, CONTINENTAL,

ECONOLINE, EXPEDITION, EXPLORER,

F-150, F-250, F-350, F-550, MOUNTAINEER,

RANGER, WINDSTAR: Secure the Mounting

Bracketto the back of the with Radio Housing

(2) 3/8" Phillips Pan-head Screws supplied.

(see Fig. A). Slide the DIN cage into the Radio Housing and secure by bending the metal

locking tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. B).

Slide the onto the Mounting Bracket and mount the Support to the back of the Rear Support

head unit using the hardware included with the unit. (see Fig. C). Skip to step #6.

Fig. A

Fig. B

Fig. C

"A"

"A"

Fig. A

"A"

"A"

Tuotetiedot