Ignis G0F L634O Käyttöohje
Ignis
Astianpesukone
G0F L634O
Lue alta 📖 käyttöohje suomeksi merkille Ignis G0F L634O (4 sivua) kategoriassa Astianpesukone. Tämä opas oli hyödyllinen 31 henkilölle ja sai 3.6 tähden keskimäärin 16 käyttäjältä
Sivu 1/4
1
ENQuick Guide
PROGRAMS TABLE
Program Programs description
Drying
phase
Auto
Door
Available options
*)
Duration
of wash
program
(h:min)
**)
Water
consumption
(litres/cycle)
Energy
consumption
(kWh/cycle)
1.
Eco 50°- Eco program is suitable to clean normally soiled ta-
bleware. that for this use. it is the most ecient program in
terms of its combined energy and water consumption. and
that it is used to assess compliance with the EU Ecodesign leg-
islation.
3:10 9.5 0.85
2.
Auto Intensive 65° - Automatic program for heavily soiled
dishes and pans (not to be used for delicate items).
2:00 - 3:10 14.0 - 17.0 1.50 - 1.85
3.
Auto Mixed 55° - Automatic program for normally soiled pans
and dishes.
1:30 - 2:30 14.5 - 16.0 1.15 - 1.30
4.
Fast&Clean 28’ 45° - Program to be used for half load of light-
ly-soiled dishes with no dried food residues. Does not have
drying phase.
-
0:28 9.0 0.60
5.
Pre-Wash - Use to refresh crockery planned to be washed lat-
er. No detergent to be used with this program.
- -
0:10 4.0 0.01
ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020. Note for Test Laboratories: For information on
comparative EN testing conditions, please send an email to the following address: dw_test_support@whirlpool.com
Pre-treatment of the dishes is not needed before any of the programs.
*) Not all options can be used simultaneously.
**) Values given for programs other than the program Eco are indicative only. The actual time may vary depending on many factors such as temperature and
pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and sensor cali-
bration. The sensor calibration can increase program duration up to 20 min.
CONTROL PANEL
1. On-O/Reset button with indicator
light
2. Program selection button with
indicator light
3. Half Load button with indicator light
4. Rinse Aid rell indicator light
5. Salt rell indicator light
6. Program indicator lights
7. Delay indicator light
8. Delay button with indicator
light
9. Tablet (Tab) button with
indicator light
10. Start/Pause button with
indicator light / Drain out
FIRST TIME USE
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and on
the machine’s functional components.
• It is mandatory that the salt reservoir never be empty.
• It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher and must be
lled when the SALT REFILL indicator light in the control panel is lit.
1. Remove the lower rack and unscrew the reservoir cap
(anticlockwise).
2. Only the rst time you do this: ll the salt reservoir
with water.
3. Position the funnel and ll the salt reservoir (see gure)
right up to its edge (approximately 1 kg); it is not unu-
sual for a little water to leak out.
4. Remove the funnel and wipe any salt residue away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get into the
container during the wash program (this could damage the water softener be-
yond repair). Whenever you need to add salt, it is mandatory to complete the
procedure before the beginning of the washing cycle to avoid corrosion.
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse
aid dispenser should be lled when the A RINSE
AID REFILL indicator light in the control pan-
el is lit. NEVER pour the rinse aid directly into the
appliance tub.
A
C
D
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device . Introduce the C
detergent into the dry dispenser only. Place the amount of detergent for D
pre-washing directly inside the tub.
If all-in-one detergents are used, we recommend using the TABLET button,
because it adjusts the program so that the best washing and drying results
are always achieved.
Usage of detergent not designed for dishwashers may cause malfunc-
tion or damage to the appliance.
WATER SOFTENING SYSTEM
Water softener automatically reduces water hardness, consequently pre-
venting scale buildup on heater, contributing also to better cleaning e-
ciency. This system regenerates itself with salt, therefore it is required
to rell salt container when empty.
Frequency of regeneration depends on water hardness level setting - regen-
eration takes place once per 6 Eco cycles with water hardness level set to 3.
Regeneration process starts in nal rinse and nishes in drying phase, be-
fore cycle ends.
• Single regeneration consumes: ~3.5L of water;
• Takes up to 5 additional minutes for the cycle;
• Consumes below 0.005kWh of energy.
3
1
2
854 6 97 10
THANK YOU FOR BUYING AN IGNIS PRODUCT.
Before using the appliance carefully read the Safety Instruction.
PLEASE SCAN THE QR CODE ON YOUR
APPLIANCE IN ORDER TO HAVE MORE
DETAILED INFORMATION
Tuotetiedot
| Merkki: | Ignis |
| Kategoria: | Astianpesukone |
| Malli: | G0F L634O |
Tarvitsetko apua?
Jos tarvitset apua merkille Ignis G0F L634O esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Astianpesukone Ignis Käyttöohjeet
16 Tammikuuta 2025
3 Tammikuuta 2025
Astianpesukone Käyttöohjeet
- Astianpesukone Kogan
- Astianpesukone Royal Catering
- Astianpesukone Summit
- Astianpesukone De Dietrich
- Astianpesukone Indesit
- Astianpesukone Kucht
- Astianpesukone Proline
- Astianpesukone Balay
- Astianpesukone Pelgrim
- Astianpesukone Porter & Charles
- Astianpesukone Cosmo
- Astianpesukone Euro Appliances
- Astianpesukone Bellini
- Astianpesukone Comfee
- Astianpesukone Vox
Viimeisimmät Astianpesukone Käyttöohjeet
9 Huhtikuuta 2025
9 Huhtikuuta 2025
9 Huhtikuuta 2025
8 Huhtikuuta 2025
8 Huhtikuuta 2025
8 Huhtikuuta 2025
7 Huhtikuuta 2025
7 Huhtikuuta 2025
7 Huhtikuuta 2025
7 Huhtikuuta 2025