CRUX SWRCR-59 Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille CRUX SWRCR-59 (3 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 39 henkilölle ja sai 4.2 tähden keskimäärin 4 käyttäjältä

RADIO REPLANTCEME

R

INTERFACING SOLUTIONS

Crux Interfacing Solutions • Chatsworth, CA 91311

phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.070524

SWRCR-59

Radio Replacement with SWC Retention for

CHRYSLER, DODGE and JEEP Vehicles

1 of 4

PRODUCT FEATURES:

NOTES:

PARTS INCLUDED:

-Retains Steering Wheel Controls via built-in, pre-programmed interface.

-Provides reverse trigger for rear view camera.

2.Also supports radio replacement in vehicles with 4.3” and 8.4” color screens.

3.Does not retaind Uconnect.

SWRCR-59 MODULE

Audio Filter

INSTALLATION DIAGRAM:

for each harness.

12-Pin Black

Connector

First Generation Harness

*Does not supply Reverse Trigger on Manual Transmissions. Reverse trigger wire from the

aftermarket radio and/or camera power must be connected to factory reverse light wire instead.

1 2 3

ON

4-Pin

Connector

Option A:

Option B:

Cap or insulate if

not being used

BLUE / YELLOW

Insulate with tape

if not being used

3.5MM SWC CABLES (Option A or B)

Use the proper 3.5MM to 4-Pin cable for your radio.

Plug in the selected 3.5MM SWC cable to the 4-pin port

on the module. See “DIP SWITCH SETTINGS” section.

AFTERMARKET

RADIO

VSS (Vehicle Speed Sense)Pink

Illumina

on (+)Orange

Power Antenna/Amp Turn on Blue/ White

Reverse Trigger* Purple/White

+12V ConstantYellow

+12V ACCRed

GroundBlack

AMPLIFIED

NON AMPLIFIED

See page 2 for

speaker wire

connections

Audio

Filter

To aftermarket

radio SWC wire

or 3.5mm port

TO FACTORY

HARNESS

4.If vehicle is not equipped with Steering Wheel Controls use part# SOOCR-26

5.If you require a dash kit with SWC interface use part# DKCR-59K

Tuotetiedot