AXESS AXLOC-150A Käyttöohje

AXESS Ei luokiteltu AXLOC-150A

Lue alta 📖 käyttöohje suomeksi merkille AXESS AXLOC-150A (3 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 28 henkilölle ja sai 4.4 tähden keskimäärin 14.5 käyttäjältä

Sivu 1/3
AXLOC-150A
INSTALL ATION I N STRUCTION S
REV. 12/18/19
© COPYRIGHT 2019 METRA ELECTRONICS CORPORATION
Integrate • AxxessInterfaces.com
Wire Color & Function: The audio and power input wire colors are an EIA standard for
car stereo applications as follows.
Note: Be sure that all audio input connections are polarized or in phase with each other.
corresponding positive input wires of the AXLOC-150A. The same goes for the negative
audio wires. Failure to do this will result in poor bass response and low quality audio.
Adjusting the AXLOC-150A for maximum performance:
After completing all of the necessary connections, turn the AXLOC-150A adjustment pots all of the
way down by rotating them completely counter-clockwise. Now, turn the stereo system on and
adjust the main volume control on the stereo to approximately 3/4 maximum volume. Select
one of the adjustment pots on the AXLOC-150A and turn it slowly clockwise until you notice audio
distortion and then stop. Turn the remaining pot to the same position as the previously adjusted
pot. The audio set-up of the AXLOC-150A is now complete and ready to be enjoyed.
INPUT HARNESS
White = LEFT Front (+) Input
White/Black = LEFT Front (-) Input
Black = Reference Ground (-)
(Reference ground optional if noise is present)
Gray = RIGHT Front (+) Input
Gray/Black = RIGHT Front (-) Input

Tuotetiedot

Merkki: AXESS
Kategoria: Ei luokiteltu
Malli: AXLOC-150A

Tarvitsetko apua?

Jos tarvitset apua merkille AXESS AXLOC-150A esitä kysymys alla ja muut käyttäjät vastaavat sinulle