Waves MaxxBass Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille Waves MaxxBass (15 sivua) kategoriassa Audio-ohjelmisto. Tämä opas oli hyödyllinen 17 henkilölle ja sai 4.9 tähden keskimäärin 9 käyttäjältä

Sivu 1/15
MaxxBass
MaxxBass Manual
1
Table of Contents
Chapter 1 QuickStart For MaxxBass............2
Chapter 2 How Does MaxxBass Work..........4
Chapter 3 Controls...................................5
Chapter 4 Mastering With MaxxBass...........7
Benefits .......................... ............. ............. ...........8
Optimizing for better playback on all Speakers...........9
Chapter 5 MaxxBass for Installed Systems...11
Chapter 6 Presets.....................................13
MaxxBass Manual
2
Chapter 1 - Quickstart for MaxxBass™
Mixing and Mastering
MaxxBass creates harmonics that you can add to the signal. These harmonics trick the ear into perceiving
low bass frequencies that may not actually be present in the output.
This psychoacoustic illusion can be used for mixing and mastering to enhance the bass response for play-
back on any system. MaxxBass can also be used to mix for installed systems, such as commercial sound sys-
tems, theme parks, outdoor distributed systems, personal stereo systems, and more.
For mastering and mixing, simply mix some of the Harmonics into the signal by raising the Harmonics
level fader. You might lower the Original Bass level a few dB as you replace its signal with the MaxxBass sig-
nal. Try to make the mix have the same amount of bass as you normally would, otherwise you run the risk
of over-using the effect, just as you might with any processor in your studio.
Recommended settings to start with for mixing and mastering are the defaults. Simply increase the
Harmonic fader to add to the mix (shown by the yellow curve in the graphic). The best Frequency will be
usually between 60 and 100. Your goal should be a smooth, warm bass response that is balanced, not more
bass than you usually would use.
Using MaxxBass for small speaker systems
This is a special case for MaxxBass. Most people will mix for normal, full-range speaker systems (you want
your mix to sound good everywhere). However, if you are mixing for a specific system, such as a kiosk,
theme park, commercial sound installation, special radio mixes, etc., you can extend the range of that sys-
tem by replacing almost all of the original bass signal with the MaxxBass signal.

Tuotetiedot

Merkki: Waves
Kategoria: Audio-ohjelmisto
Malli: MaxxBass

Tarvitsetko apua?

Jos tarvitset apua merkille Waves MaxxBass esitä kysymys alla ja muut käyttäjät vastaavat sinulle




Audio-ohjelmisto Waves Käyttöohjeet

Audio-ohjelmisto Käyttöohjeet

Viimeisimmät Audio-ohjelmisto Käyttöohjeet