Valcom VP-6124-UPS Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille Valcom VP-6124-UPS (8 sivua) kategoriassa Akkulaturi. Tämä opas oli hyödyllinen 37 henkilölle ja sai 4.0 tähden keskimäärin 6 käyttäjältä

VSPVP---6124UPS

Issue 3

1947271

VP--6124UPS

ADD ON OPTION FOR THE VP---6124/VP6124E

POWER SUPPLY

INTRODUCTION

The VP--6124UPS is an optional unit that allows the

VP---6124/VP6124E to supply power during a power

outage.

The VP----6124UPS is comprised of a VP6124UPS

(Charger) and a VBB-1424 (Battery Enclosure). The

VP---6124UPS connects to the VP6124 Power Supply

(To receive power to charge the batteries).

Listed below are specifications and recommendations

for power sources as well as precautionary

instructions.

UPS Float Standby Charging

Charging Voltage: 27.6 Volts (13.8 Volts per battery)

Current Limit: 900mA charging

100mA at 27 Volts final charge

Fusing: 1 Amp auto-reset polyswitch

6 Amps accidental reverse battery polyswitch

Time Required to Recharge Battery

7AH Battery: 14 hours

Length of Time Battery Will Provide

Power

•With four 7AH 12V batteries for 14AH total

3 Amps load draw:3 hours run time

6 Amps full load: 1.5 hours run time

Use of batteries greater than 7AH is not

recommended since 90% of all power outages are less

than an hour in length and the time to evacuate a

building is less than an hour.

NOTE: To insure trouble--free UPS backup

operation, five years batteries must be replaced five

years from the date of manufacturing.

DIMENSIONS/WEIGHT

•10.30"H x 3.50"W x 2.25"D

•(26.16cm H x 8.89cm W x 5.72cm D)

2.90 lbs. (1.32 kg)

INSTALLATION

The VP--6124UPS (Charger) is designed for wall

mounting only. Screw the mounting plate to the wall

near the VP---6124/VP6124E and position the

VP--6124UPS onto the mounting plate.

Attach the UPS unit securely to the bracket lip using

the 6--32 x 3/8" long Phillips head selftapping screw

supplied. Place the VBB-1424 on the floor within six

feet of the unit.

CONNECTIONS

•Disconnect AC power from the power supply.

•Remove plug button from the VP---6124/VP6124E.

•Remove wire access cover from the

VP---6124/VP6124E.

•Using the cable designated by the tag labeled

Valcom P/N WA-784 with four positions

connector and attached to VP--6124UPS

(Charger), place the Molex connector through the

hole on the power supply and connect the

charger to the Molex input connector on the

VP-6124 Power Supply.

•Snap strain relief into place.

•Replace wire access cover on the

VP---6124/VP6124E.

•Remove cover from Battery Backup.

•Push cable labeled Valcom P/N WA-783 with two

positions connector through the hole on the

battery enclosure and snap strain relief into

place.

Tuotetiedot