Valcom VIP-854 Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille Valcom VIP-854 (3 sivua) kategoriassa Puhelin. Tämä opas oli hyödyllinen 32 henkilölle ja sai 4.2 tähden keskimäärin 4 käyttäjältä

1 947644

CAUTION: To reduce the risk of electric shock,

Do not remove cover.

No user serviceable parts inside.

Refer servicing to qualified service personnel.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This symbol indicates that dangerous

voltage constituting a risk of electric

shock is present within this unit.

This symbol indicates that there are

important operating and maintenance

instructions in the literature accompanying

this unit.

ISSUE 2

VIP-854

NETWORK TIE LINE MODULE

INTRODUCTION

The VIP-854 Network Tie Line Module allows two

end-points to be connected via an Ethernet

connection, bridging m

ultiple trunk & station lines.

SPECIFICATIONS

Access Methods

2 PBX, FXO (Trunk) Ports

2 PBX, FXS (Station) Ports

Features

RJ-45 for network connection

2 RJ-11 FXO (Trunk) Ports

2 RJ-11 FXS (Station) Ports

2 Failover Phone Ports

2 Relays with Form C contacts

Front Panel Status & Network LEDs

2.5mm Barrel Power Connector

Power over Ethernet (802.3af) compliant

Dimensions/Weight

1.38" H x 6.13" W x 5.25" D

(3.50cm H x 15.6cm W x 13.33cm D)

Weight: 1.25 lbs. (0.57 kg)

Nominal Specifications

Input Impedance: 600 Ohms

Input Level: -10dBm

Output Impedance: 600 Ohms

Output Level: - 10dBm nominal

Relay Current: 1 AMP @ 24VDC

Nominal Power Requirements

Via rear panel barrel connector:

Voltage: 24VDC

Current: 325mA

Via Power over Ethernet (802.3af) Switch:

802.3af: Class 3

Environment

Temperature: 0 to +40° C

Humidity: 0 to 85% non-precipitating

Packing List

Qty Item

1 VIP-854

1 VSP Document

2 Mounting Brackets w/ Hardware

4 Rubber Pads

INSTALLATION

NOTE: The telephone system referred to in

this manual is the customer premise

equipment such as an electronic key system,

a PBX or a dedicated single line telephone

sets. The VIP-854 is not intended for direct or

indirect connection to the public telephone

network. When used with a customer premise

telephone system such as a key system or

PBX system, these units are interfaced to the

FXS or single line station port, which is a fully

protected interface device. Also, the host

system must be configured to disallow central

office trunk conferencing in order to prevent

indirect connection to the public network.

Precautionary Designations

Tuotetiedot