Trendnet TC-NT3 Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille Trendnet TC-NT3 (11 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 9 henkilölle ja sai 5.0 tähden keskimäärin 5 käyttäjältä

Sivu 1/11
TC-NT3(V1) /10.30.2014
TC-NT3
VDV & USB Cable Tester
ENGLISH
1
Remote Terminator
1
USB 2.0/3.0 Port Network/Phone Port
USB 2.0/3.0 PortNetwork/Phone Port
LED Indicators
Test Button
Power On/Off
Switch
Active Network
Link LED
Mode Selection
Button
Transmitter
Getting to know TC-NT3
ENGLISH
Slide the bottom of the TC-NT3 Remote Terminator towards the back of
the TC-NT3 Transmitter.
1. Change the battery if the Battery Low ( ) LED is on. B/L
2. Slide the battery cover off the TC-NT3 transmitter.
3. Connect and insert the battery.
4. Slide the battery cover back on to the TC-NT3 remote transmitter.
How to Separate the Transmitter and Terminator
Install / Replace the Battery (9V Alkaline battery is not included)
Warning and Caution
1. This device is designed to be used on a cabling system without voltage. Do not
connect the TC-NT3 to any live circuits, lines or outlets. Doing so may damage
the TC-NT3 and equipment.
2. Disconnect cables from all electronic equipment with voltage before testing.
Failure to do so may damage the TC-NT3.
2

Tuotetiedot

Merkki: Trendnet
Kategoria: Ei luokiteltu
Malli: TC-NT3

Tarvitsetko apua?

Jos tarvitset apua merkille Trendnet TC-NT3 esitä kysymys alla ja muut käyttäjät vastaavat sinulle