Tactical Fiber Systems CCRT242 Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille Tactical Fiber Systems CCRT242 (2 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 54 henkilölle ja sai 4.0 tähden keskimäärin 9 käyttäjältä

1525 NW 3

rd

Street, Deereld Beach, FL 33442877-777-7147 www.TacticalFiber.com

TFS ClearCom/RTS 2 wire to 4 wire InterCom Interface - Mod.CCRT242

Installaon and Operang Instrucons with ATEM Studio Converter 2

Product Descripon

TFS's CCRT24 interface connects a 2 wire Clear-Com or RTS base staon to the Blackmagic ATEM Studio

Converter or Studio Converter 2 's four wire intercom system . The Clear-Com or RTS base staon

becomes the master intercom and communicates to both wired or wireless party line/matrix belt-paks

and the ATEM camera converters linked to the Studio Converter over ber.

Installation

Connect the Clear-Com or RTS base staon to the CCRT24 interface using a 3PIN XLR cable from any

intercom output channel. NOTE: The CCRT24 is powered by the Clear-Com or RTS base staon.

Connect the ATEM Studio Converter to the CCRT24 interface using the interface cable designed for

STUDIO CONVERTER 2. (Note: The original STUDIO CONVERTER comes with a dierent cable.) One end

has a 16 pin DIN connector which aaches to the CCRT24. The other end has two break-out cables for

connecon to the Studio Converter's Mic and Headset sockets. Insert the BLACK .20" connector plug

into the MIC input and the grey 1/4" TRS plug into the HEADSET sockets on the Studio Converter.

DIP Switch Positions

The dip switch sengs at the rear of the CCRT241 should be set as follows:

Switch 1 - (up) ON

Switch 2 - ClearCom - OFF (down) RTS -ON(up)

Calibrating the Interface

Your TFS CCRT24 Clear-Com/RTS interface was factory nulled with an MS-702 Clear-Com base staon

aached to a Blackmagic ATEM Studio Converter. You may have to tweak the null adjustments to match

your parcular Studio converter using an ear set and a small screwdriver. To null the interface, plug in

the ear set into the 1/8" jack to the right of the interface and adjust the RLC trim pots for minimum

noise...then unplug the ear set. IMPORTANT: You must unplug the ear set aer nulling the interface

Tuotetiedot