Summit CKPUMPKIT Käyttöohje
Summit
Ei luokiteltu
CKPUMPKIT
Lue alta 📖 käyttöohje suomeksi merkille Summit CKPUMPKIT (4 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 9 henkilölle ja sai 3.6 tähden keskimäärin 5 käyttäjältä
Sivu 1/4

CKPUMPKIT
Assembly Instructions for Your Kitchenette Water Pump
MODELS:
C48ELPUMP
C48ELGLASSPUMP
Write Serial Number (on lower left corner of
inside cabinet) here:
Serial No.: _______________________
Felix Storch, Inc.
An ISO 9001:2015 registered company
770 Garrison Avenue
The Bronx, NY 10474
www.summitappliance.com

Summit Appliance Division · Felix Storch, Inc. · www.summitappliance.com · 718- -3900 · info@summitappliance.com893
Pump Kit Installation CKPUMPKIT –
Component
Quantity
Bottled Water Dispenser Pump System,
20ft 110V AC US Plug Water Dispensing
Pump
1
5 Gallon Freshwater Container
1
6 Gallon Waste Container
1
3/8 in. Brass Water Cut-o Valve
1
1/4" Acetal Copolymer Compression
Sleeve
1
20 in. Length Braided Stainless Steel
Faucet Connector
2
1- -in Flexible Plastic Drainage Pipe 1/2
1

Summit Appliance Division · Felix Storch, Inc. · www.summitappliance.com · 718- -3900 · info@summitappliance.com893
1/2 in. x 520 in. White Teon Tape
1
Mounting Template (18x12)
1
10-32 x 1 1/4" Phillips Head Truss Screw
Stainless Steel
4
10-32 Nylon Lock Nut Stainless Steel
4
10 x 5/8" Fender Washer Stainless Steel
4
Installation Instructions
1) Open the cabinet of your combo kitchen. Move the wire shelf to the oor of the cabinet. This is to
ensure nothing sits directly on the floor, keeping any cords or wires dry.
2) To install the faucet, set the gasket on top of the pre-drilled holes of the combo kitchen.
3) Insert the water faucet thought the gasket and secure the faucet with the provided nuts on the
underside of the sink.
4) The pump will be secured to the outer wall of the combo kitchen, using four machine screws and
nuts.
5) Place the provided template on the left side of the combo kitchen, in the top-right corner. It should
align to the front edge and along the bottom edge of the stainless steel top.
6) Using a drill bit, drill the four template holes. ¼”
7) Secure the pump to the interior wall of the cabinet, using the four provided screws, washers, and
nuts. Be sure the screw heads are on the outside of the cabinet.
NOTE: If mounting is not possible for your particular set-up, the pump can be placed on the oor of the
cabinet. It is recommended to place it, so the ON/OFF switch is accessible.
Tuotetiedot
Merkki: | Summit |
Kategoria: | Ei luokiteltu |
Malli: | CKPUMPKIT |
Tarvitsetko apua?
Jos tarvitset apua merkille Summit CKPUMPKIT esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Ei luokiteltu Summit Käyttöohjeet
15 Lokakuuta 2024
15 Lokakuuta 2024
15 Lokakuuta 2024
15 Lokakuuta 2024
15 Lokakuuta 2024
Ei luokiteltu Käyttöohjeet
- Ei luokiteltu Eufy
- Ei luokiteltu Sabrent
- Ei luokiteltu Phil And Teds
- Ei luokiteltu EAT
- Ei luokiteltu Weston
- Ei luokiteltu Boss
- Ei luokiteltu Laurastar
- Ei luokiteltu NovaStar
- Ei luokiteltu Frilec
- Ei luokiteltu Gator
- Ei luokiteltu SKB
- Ei luokiteltu Haier
- Ei luokiteltu Aruba
- Ei luokiteltu Netter Vibration
- Ei luokiteltu Flame
Viimeisimmät Ei luokiteltu Käyttöohjeet
9 Huhtikuuta 2025
9 Huhtikuuta 2025
9 Huhtikuuta 2025
9 Huhtikuuta 2025
9 Huhtikuuta 2025
9 Huhtikuuta 2025
9 Huhtikuuta 2025
9 Huhtikuuta 2025
9 Huhtikuuta 2025
9 Huhtikuuta 2025