StarTech.com ADJ-TABLET-STAND-W Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille StarTech.com ADJ-TABLET-STAND-W (2 sivua) kategoriassa Muut puhelintarvikkeet. Tämä opas oli hyödyllinen 35 henkilölle ja sai 3.9 tähden keskimäärin 18 käyttäjältä

Sivu 1/2
Quick-Start Guide
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support
Manual Revision: June 20, 2022 4:53 PM
Product Diagram (ADJ-TABLET-STAND-W)
Front View
Component Function
1Clamp
For up to 12.9 in . on either side Tablets Holders
Width range from 5 to 8 in (12.8 to 22.4 cm)
Maximum thickness 0.4 in (1.1 cm)
Allow to rotate 360°, up and down, and side to side
2
Rotation Adjustment
Knob
Varies the resistance of the or xes it Rotation Clamp
on a specic position
3
Clamp Tilt
Adjustment Screw
Adjust the of the of the Resistance Tilt Angle Clamp
4
Support Arm Tilt
Adjustment Screws
Adjust the of the of the Resistance Tilt Angle Upper
and sections of the Lower Support Arm
5Support Arm
Supports the weight of the and provides Tablet
Height Tilt Adjustment and
6Mounting Holes Allow to x the on a permanent locationTablet Stand
7Base
Supports the in place. at the Assembly Foam Pads
bottom protect the desk or table surface
Universal Tablet Desk Stand - White
Package Contents
Tablet Stand x 1
4.2x19 mm Wood Screws x 4
3 mm Hex Key x 1
5 mm Hex Key x 1
Quick-Start Guide x 1
Requirements
For the latest manuals, product information, technical specications, and declarations of
conformance, please visit: www.startech.com/ADJ-TABLET-STAND-W
Phillips head screwdriver
Operation
WARNINGS!
Do not exceed the weight capacity of this product. Overloading this product might
result in injury or property damage. This product can support the following weight: up
to 2.2 lb (1 kg).
When adjusting the tilt or height of this product, ensure that the mounted equipment
is properly secured and the weight is fully supported. Failure to follow these guidelines
may result in property damage and/or personal injury.
When not xed to a surface, always use two hands to ensure a controlled movement
when adjusting the height or tilt angle of this product to prevent tipping it over.
Is recommended to remove any protective case from the Tablet to t properly on the
Holders.
1. Slide the outwards to make enough room to mount the Holders Tablet Vertically
on the If the is enough, it can be mounted too. Clamp. Tablet Small Horizontally
Figure 1
7
6
1
5
2
4
4
3
*Product may vary from image

Tuotetiedot

Merkki: StarTech.com
Kategoria: Muut puhelintarvikkeet
Malli: ADJ-TABLET-STAND-W

Tarvitsetko apua?

Jos tarvitset apua merkille StarTech.com ADJ-TABLET-STAND-W esitä kysymys alla ja muut käyttäjät vastaavat sinulle