Rockustics OneSub Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille Rockustics OneSub (2 sivua) kategoriassa Subwoofer. Tämä opas oli hyödyllinen 29 henkilölle ja sai 4.9 tähden keskimäärin 15 käyttäjältä

Sivu 1/2
OneSub & DubSub
INSTALL INSTRUCTIONS
© 2021 MSE Audio. Rev. 02.19.2021
Ultra-Fidelity Outdoor Speakers
Contact: MSE Audio, 855.663.5600 / 913.663.5600 / sales@mseaudio.com
Please read the following instructions carefully before installing
your Rockustics
®
Rock speaker. If you have any questions
directions, please contact your local sound contractor or the
Rockustics
®
/MSE Audio
®
technical support team.
OneSub™
The terminal block is on the underside of the OneSub. 14 gauge
or heavier direct burial wire should be run directly from an
amplier with an integrated low frequency crossover (We
recommend a Phase Technology P350 amplier. Please see
P350 manual to setup crossover point.) to the speaker location.
Stripped wire ends are then inserted into the terminal blocks.
DubSub™
The dual terminal blocks are on the underside of the DubSub. 14
gauge or heavier direct burial wire should be run directly from a
dual channel full range amplier. The DubSub has an integrated
crossover that will route the low frequencies to the DubSub, and
the rest of the signal to the satellite speakers.
Wires from the ampliifer are wired to the ‘in’ terminals, and
satellite speakers are wired to the ‘out’ terminals.
INPUT
12V TRIGGER
UNBALANCEDBALANCED
OUTPUT
TRIGGER
MODE
IN OUT
MUSIC
ON
12V
4-16 OHMS
INPUT
VOLTAGE
POWER
ON OFF
115V 60 Hz/ 230V 50 Hz
AC INPUT 600W MAX
PUSH
115V
+
+
-
-
P350
Terminal Block
OS-440
L R
L IN
L OUT
R OUT
R IN
Out
+
-
+
-
In
Out
+
-
+
-
In

Tuotetiedot

Merkki: Rockustics
Kategoria: Subwoofer
Malli: OneSub

Tarvitsetko apua?

Jos tarvitset apua merkille Rockustics OneSub esitä kysymys alla ja muut käyttäjät vastaavat sinulle