PAC WRI-P Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille PAC WRI-P (2 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 42 henkilölle ja sai 4.5 tähden keskimäärin 21.5 käyttäjältä

Sivu 1/2
1
11-17-09
WRI-P
Wired Remote Input Control Interface
Before You Start
A. Prepare for the installation.
• If possible, install the WRI-P while you are installing the new head unit.
• Plan a general installation location for both the WRI-P infrared eye and the control body.
• If you are installing the WRI-P in conjunction with a SWI-PS, please refer to the SWI-PS instructions for all wiring
Pacific Accessory Corporation
IP-BUS input
Antenna jack
Power
To Infrared Eye
Fuse
Jack for the SWI-PS
IP-BUS cable
WRI-P
Installation Instructions
Compatible with Pioneer in-dash
navigation units that lack an IR receiver
but have a wired remote input.
Wiring Connections
Step 1.
Connect the BLACK
wire to ground (-).
Verication: Wire
or location registers
a constant (-) when
probed.
Step 2.
Connect the RED wire
to switched +12V.
Verication: Wire reg-
isters +12V when the
ignition key is turned
to the ACC or ON posi-
tions.
WRI-P
Black
Red
WRI-P
Black
Red 12V+ (Switched)

Tuotetiedot

Merkki: PAC
Kategoria: Ei luokiteltu
Malli: WRI-P

Tarvitsetko apua?

Jos tarvitset apua merkille PAC WRI-P esitä kysymys alla ja muut käyttäjät vastaavat sinulle