PAC MCI-FD22 Käyttöohje
Sivut 3 Engels Ei luokiteltu
Lue käyttöohje merkille PAC MCI-FD22 ilmaiseksi verkossa tai lataa PDF. Ohje on ollut hyödyllinen 48 henkilölle. Kysyttävää mallista? Esitä kysymys
Multi Camera Input Interface
for Select Ford Vehicles
MCI-FD22
© 2017 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
C
Page 1
Rev. 070617
The MCI-FD22 will allow the addition of front, and blind spot cameras, in vehicles equipped with the 4.2” screen and a
factory reverse camera. The MCI-FD22 has multiple user proles that can be set using the DIP switches or by PC app.
The MCI-FD22 also has on-demand activation of rear or front camera.
Introduction & Features
Important Notes
1. Only compatible in vehicles equipped with the 4.2” screen and a factory reverse camera.
2. The accessory output is rated at 10A of current. If more current is needed an external relay must be used.
3. All DIP switches must remain in the off (up) position in order to set up the MCI with the app.
DIP switchesBlind Spot Camera OperationFront Camera Operation
All Off (up)PC SetupPC Setup
1 onOn with Turn SignalOff
2 onOn with Turn SignalOn with Shift to Drive, then Off with MPH > 6 MPH or 30s
1,2 on
On with Turn Signal and MPH
> 0
Off
3 on
On with Turn Signal and MPH
> 0
On with Shift to Drive, then Off with MPH > 6 MPH or 30s
1,3 on
On with Turn Signal and MPH
> 20
Off
2,3 on
On with Turn Signal and MPH
> 20
On with Shift to Drive, then Off with MPH > 6 MPH or 30s
1,2,3 onDouble Tap Turn SignalOff
4 onDouble Tap Turn SignalOn with Shift to Drive, then Off with MPH > 6 MPH or 30s
2,3,4 onOn with Shift to Drive, then Off with MPH > 6 MPH or 30sOff
All On (down)OffOff
Set DIP switches to the ON position to activate the corresponding features.
Set DIP switches to the OFF position for any features that are not desired.
***All DIP switches must remain in the off (up) position in order to set up the MCI with the PC
Installation
Module Layout
LED 1
LED 2
Interface
Connector 1
Expansion Port
(For VS41 Connection)
Interface Connector 2
Reset Button
USB Port
(For Firmware
Updates)
Feature Select
DIP switches
Tuotetiedot
| Merkki: | PAC |
| Kategoria: | Ei luokiteltu |
| Malli: | MCI-FD22 |
Tarvitsetko apua?
Jos tarvitset apua merkille PAC MCI-FD22 esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Ei luokiteltu PAC Käyttöohjeet
PAC BT-SWC-NI1 Käyttöohje PAC NU-GM4 Käyttöohje PAC MCI-GM53 Käyttöohje PAC BCI-FD21 Käyttöohje PAC SWI-X Käyttöohje PAC GM6A-RST Käyttöohje PAC C2A-CHY Käyttöohje PAC SRK-GM14HX Käyttöohje