Liftmaster SRDRST Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille Liftmaster SRDRST (6 sivua) kategoriassa Kulunvalvontajärjestelmä. Tämä opas oli hyödyllinen 41 henkilölle ja sai 4.5 tähden keskimäärin 3 käyttäjältä

1

SMART READER

INSTALLATION GUIDE

Included Parts:

• Reader, Backplate, Wall Plate

• #6 Machine Screws – QTY 2

• #6 Self Tapping Screws – QTY 2

• #4-40 Phillips Screw

• #4-40 Pin-in-Torx Screw

Wiring Connections

RedPower In

BlackGround

Shield Shield Ground

GreenWiegand Data 0

RS485A(+)

WhiteWiegand Data 1

RS485A(–)

Yellow*Beeper Control

Brown*Tamper Out

Blue*Green LED Control

OrangeRed LED Control*

•

Single GangKeypad

RF TECHNOLOGIESModelModel

125 kHz, 13.56 MHz & BLE MobileSRDRSTSRDRKP

CURRENT120 mA average, 170 mA peak145 mA average, 195 mA peak

VOLTAGE5-16 VDC (NEVER APPLY MORE THAN 16V)

TEMPERATURE

UL™ tested –35° to 66°C and EN –40° to 70°C and 95% humidity

(UL™ tested -31˚F to 150˚F and EN -40˚ to 158˚F and 95% humidity)

CABLE LENGTH

Communication Lines

Wiegand: 200 feet - 22 AW G

300 feet - 20 AWG

500 feet -18 AWG

OSDP @ 12 VDC and 25˚C (77˚F) = 1000 feet - 22 AWG Twisted Pair

NOTE: Do NOT use the Power Supply provided with the CAPXLV or CAPXM to directly power up this reader. It is 24V and will cause damage to the reader.

NOTE: LED Control not available when connected to a CAPXS.

Tools Needed (Not Supplies):

• Phillips Screwdriver

• 1” (25 mm), 1/8” Drill bits

• T8 Security Torx Bit (optional for increased tamper detection)

• #6-32 Tap if required

*These wires are only used in Wiegand mode.

**All wiring methods used shall be in accordance

with the National Electrical Code, ANSI/NFPA 70.

Readers must be powered by a compatible UL

Listed, power limited, access control panel rated

5–16 VDC.

A. Install the Metal Wall Plate to the Wall/Single Gang box.

• Use the provided #6 screws.

B. Wire the Cable to the Control Panel.

C. Attach the Reader to the Wall Plate and Install the Reader Screw.

• Follow steps 1 through 3 below to ensure proper alignment. Install either the #4-40

screw or Pin-in-Torx screw at the bottom.

WARNING: This product can expose you to chemicals including lead, which are known

to the State of California to cause cancer or birth defects or other reproductive harm.

For more information go to www.P65Warnings.ca.gov.

Tuotetiedot