Hobbywing Ezrun 1626 Käyttöohje
Hobbywing
Radio-ohjattavat lelut
Ezrun 1626
Lue alta 📖 käyttöohje suomeksi merkille Hobbywing Ezrun 1626 (1 sivua) kategoriassa Radio-ohjattavat lelut. Tämä opas oli hyödyllinen 24 henkilölle ja sai 4.3 tähden keskimäärin 12.5 käyttäjältä
Sivu 1/1
Thank you for purchasing this HOBBYWING product! The
power of brushless power system is powerful. Any
improper use may cause personal injury and damage to the
product and related devices. We strongly recommend
reading through this user manual before use and strictly
abide by the specified operating procedures. We shall not
be liable for any liability arising from the use of this
product, including but not limited to reimbursement for
incidental or indirect losses. Meanwhile, we do not assume
any responsibility caused by unauthorized modification of
the product. We have the right to change the product
design, appearance, performance and use requirements
without notice.
CAUTIONS
ATTENTION
P Lart sist
02 Features
04 I sn ta at on onne t onll i &Cci
05 Gear ngi
06 A emb y and D a emb yss l is ss l
03 Spe f at onci icis
01 Warn ngis
• Specially designed for 1/28 mini car when matched with Hobbywing EZRUN MINI28 esc, it has perfect compatibility, and provides ，
better performance and more delicate manipulating feel.
• The front and rear ends of the motor are designed with large openings structure to provide better heat dissipation for the motor.
• Built in high-precision Hall sensor combined with the high precision and balanced rotor to ensure excellent linearity of the motor.
• The internal PCB is a 4-layer board, and the ABC wiring position is reinforced by punching holes,prevent the soldering spot from falling
off after multiple soldering.
• Please carefully check power devices and manual of car frame to ensure the power pairing is reasonable. Avoid wrong pairing to
overload and damage the motor.
• Always wire up all the parts of the equipment carefully. If any of the connections come loose as a result of vibration, your model RC
may lose control.
• Never apply full throttle if the pinion is not installed. Due to the extremely high RPMs without load, the motor may get damaged.
• Never allow the motor case to get 100 degrees Celsius (212 degrees Fahrenheit) because the magnets maybe demagnetized by high
temperature.
In order to make the motor have longer service life and higher efficiency, we suggest to regularly check the bearing and clean the dirt in the
motor. The specific time depends on the frequency of using the motor and the site conditions. When installing, please follow the steps in the
following assembly drawing; when disassembling, follow the reverse steps.
Reasonable selection of gear ratio is very important. Improper gear ratio may bring you great loss. You can select the gear ratio according
to the following points!
1. The running temperature of the motor
The motor temperature should be lower than 100 degrees Celsius (212 degrees Fahrenheit) in operation. Because high temperature
may cause the magnets to get demagnetized, the coil to get melt and short circuited, and the ESC to get damaged. A suitable
gearing ratio can effectively prevent the motor from overheating.
2. The principle of selecting gear ratio
To avoid the possible damage to ESC and motor caused by the overheat, please start with a small pinion/a big FDR and check the
motor tempera ture regularly. If the motor and ESC temperature always stay at a low level during the running, you can change a big
pinion/a low FDR and also check the motor temperature regularly to ensure that the new FDR is suitable for your vehicle, local weather
and track condition. (Note: For the safety of electric devices, please check the ESC and motor temperature regularly.)
1. Install the motor
There are 8 motor mounting holes in M2 specification, and the mounting holes are 2.5mm in depth, before installing the motor on
the vehicle, please carefully confirm whether the specification of the screws is appropriate according to the thickness of the motor
mounting plate to avoid damage to the motor due to too long screws.
2. How to Connect the Motor to an ESC
• When connecting the motor and esc, please pay attention to the marked three-phase position of A, B and C to ensure that the three
wires of the motor and esc are connected correspond ingly. Otherwise, it cannot run normally and even damage the esc and motor.
That is: Wire A of the esc matches wire A of the motor, wire B of the esc matches wire B of the motor, wire C of the esc matches wire C
of the motor.
• Connecting the sensor cable to the motor and esc.
3. Inspection
Before power on the esc, please check the reliability of the motor installation and the correctness of all connections.
Model
EZRUN-1626SD-3500KV
EZRUN-1626SD-5000KV
EZRUN-1626SD-6500KV
3500KV
5000KV
6500KV
KV
LiPos
0.4A
0.5A
0.6A
No-load
Current
(A)
Diameter/Length
(mm)
2S
ϕ=16mm (0.63in)
L=26mm (1.02in)
ShaftDiameter/
Length (mm)
ϕ=2.0mm (0.08in)
L=8.5mm (0.33in)
Bearing size
(mm)
D5*D2*T2.5
Poles
2
Weight
(g)
1/28 Mini
Applications
18g
USER MANUAL
EZRUN 1626SD
Sensored Brushless Motor
20221026
8
18.5
16
(
0.62")
8.5
±0.5
26
±0.2
(1.02")
1.80
2
（
0.78")
8-M2 EQS
12
(
0.47")
45°EQS
C.C.W
Rear End Bell x 1Pcs
Screws for Fastening
the Rear End Bell x 2Pcs
(M1.6 x 4mm)
Stator Set x 1Pcs
Rotor x 1Pcs
1. Mount the motor rotor
3. Mount screws for fastening
the rear end bell 4. Picture of the assembled motor
2. Mount the rear end bell set
1 2
3 4
(A)
(C)
(B)
Battery
Electronic Speed Controller
Receiver
Motor
Sensor wire
Sensor port of motor
Tuotetiedot
| Merkki: | Hobbywing |
| Kategoria: | Radio-ohjattavat lelut |
| Malli: | Ezrun 1626 |
Tarvitsetko apua?
Jos tarvitset apua merkille Hobbywing Ezrun 1626 esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Radio-ohjattavat lelut Hobbywing Käyttöohjeet
29 Maaliskuuta 2025
29 Maaliskuuta 2025
28 Maaliskuuta 2025
28 Maaliskuuta 2025
27 Maaliskuuta 2025
27 Maaliskuuta 2025
27 Maaliskuuta 2025
27 Maaliskuuta 2025
27 Maaliskuuta 2025
27 Maaliskuuta 2025
Radio-ohjattavat lelut Käyttöohjeet
- Radio-ohjattavat lelut Absima
- Radio-ohjattavat lelut Revell
- Radio-ohjattavat lelut DF-Models
- Radio-ohjattavat lelut Axial
- Radio-ohjattavat lelut Spektrum
- Radio-ohjattavat lelut Reely
- Radio-ohjattavat lelut Robbe
- Radio-ohjattavat lelut Conrad
- Radio-ohjattavat lelut Carson
- Radio-ohjattavat lelut Amewi
- Radio-ohjattavat lelut E-flite
- Radio-ohjattavat lelut FMS
- Radio-ohjattavat lelut Blade
- Radio-ohjattavat lelut MJX
- Radio-ohjattavat lelut ROCHOBBY
Viimeisimmät Radio-ohjattavat lelut Käyttöohjeet
31 Maaliskuuta 2025
30 Maaliskuuta 2025
30 Maaliskuuta 2025
30 Maaliskuuta 2025
30 Maaliskuuta 2025
30 Maaliskuuta 2025
29 Maaliskuuta 2025
29 Maaliskuuta 2025
29 Maaliskuuta 2025
29 Maaliskuuta 2025