GVision VW49CD-OD-40003 Käyttöohje
Lue alta 📖 käyttöohje suomeksi merkille GVision VW49CD-OD-40003 (23 sivua) kategoriassa Monitor. Tämä opas oli hyödyllinen 17 henkilölle ja sai 3.9 tähden keskimäärin 9 käyttäjältä
Sivu 1/23
[Firmware Version : v.010]
WWW.GVISION-USA.COM
VIDEO WALL USER’S
MANUAL
4K Resolution Proc
essor Board
GVISION USA, INC
30398 Esperanza, Rancho
Santa Margarita, CA 92688 / 949.586.3338 / info@gvision-usa.com
WARNING
Before operating the set, please read this manual carefully.
WARNING :
To reduce the risk of electric shock does not remove cover (or back). No user serviceable parts insid e.
Refer servicing to qualified service personnel. To prevent fire or shock hazard, do not expose the rear of
the set to rain or moisture. Do not rub or strike the Active Matrix LCD with anything hard as this may
scratch, mark, or damage the Active Matrix LCD permanently.
CAUTION :
Unauthorized tampering with the inside of the monitor invalidates the warranty.
The manufacturer shall not warrant for any damage caused by improper maintenance and/or repair
work by third parties.
Important safeguards for you and your new product :
Your product has been manufactured and tested with your safety in mind. However, improper use c an
result in potential electrical shock or fire hazards. To avoid defeating the safeguards that have been built
into your new product, please read and observe the following safety points when installing and using
your new product and save them for future reference.
1. Read Instructions
2. Follow Instructions
All operating and use instructions should be followed.
3. Retain Instructions
The safety and operating instructions should be retained for future reference.
4. Heed Warnings
All warnings on the product and in the operating instructions should be adhered to.
5. Cleaning
Disconnect the unit from the electricity supply before cleaning. Do not use abrasive cleaners. Use a
damp cloth for cleaning.
WWW.GVISION-USA.COM
GVISION USA, INC. 30398 Esperanza, Rancho Santa Margarita, CA 92688 / Phone. 949-586-3338 / Fax. 949-272-4594 / Email. info@gvision-usa.com
2
WARNING (cont)
6. Water and Moisture
Do not use this apparatus near water.
7. Transporting Product
A product and cart combination should be moved with care. Quick stops, excessive force and uneve n
surfaces may cause the product and cart combination to overturn.
8. Attachments
Do not use attachments not recommended by GVision USA.
9. Ventilation
Do not block any of the ventilation openings.
Install in accordance with the manufacturer’s instructions.
10. Power Sources
This product should be operated only from the type of power source indicated on the marking label.
If you are not sure of the type of power supply to your home, consult your supplying dealer.
11. Power Lead Polarization
This product is equipped with a three-wire grounding-type cord. This is a safety feature. Do not def eat
the safety purpose of the grounding-type cord.
12. Power Cord Protection
Power-supply cords should be routed so that they are not likely to be walked on or pinched by ite ms
placed upon or against them, paying particular attention to cords at plugs, convenience receptac les and
the point where they exit from the product.
13. Outdoor Antenna Grounding
If an outside antenna or cable system is connected to the product, be sure the antenna or cable s ystem
is grounded so as to provide some protection against voltage surges and built-up static charg es. A “face
plate” also needs to be installed with an isolating capacitor to prevent any damage fro m static.
14. Lightning
For added protection for this product during a lightning storm, or when it is left unattended and un used
for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable s ystem.
This will prevent possible damage to the product due to lightning and power-line surges.
15. Power Lines
An outside antenna system should not be located in the vicinity of overhead power lines or other el ectric
light or power circuits, or where it can fall into such power lines or circuits. When installing a n outside
antenna system, extreme care should be taken to avoid contact with such power lines or circuits, as
contact with them might be fatal.
16. Earthing the product
This product must be earthed properly to comply with the safety regulations in the country of use. If you
are unsure of these regulations, please consult a qualified electrician.
WWW.GVISION-USA.COM
GVISION USA, INC. 30398 Esperanza, Rancho Santa Margarita, CA 92688 / Phone. 949-586-3338 / Fax. 949-272-4594 / Email. info@gvision-usa.com
3
Tuotetiedot
| Merkki: | GVision |
| Kategoria: | Monitor |
| Malli: | VW49CD-OD-40003 |
Tarvitsetko apua?
Jos tarvitset apua merkille GVision VW49CD-OD-40003 esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Monitor GVision Käyttöohjeet
4 Maaliskuuta 2025
12 Tammikuuta 2025
11 Joulukuuta 2024
11 Joulukuuta 2024
11 Joulukuuta 2024
19 Lokakuuta 2024
19 Lokakuuta 2024
19 Lokakuuta 2024
19 Lokakuuta 2024
19 Lokakuuta 2024
Monitor Käyttöohjeet
- Monitor X-Rite
- Monitor Advantech
- Monitor Extron
- Monitor KeepOut
- Monitor MSI
- Monitor Triton
- Monitor Ag Neovo
- Monitor Xenarc
- Monitor Fujitsu
- Monitor Festo
- Monitor Japannext
- Monitor JVC
- Monitor Kramer
- Monitor BlueBuilt
- Monitor TRIUMPH BOARD
Viimeisimmät Monitor Käyttöohjeet
8 Huhtikuuta 2025
8 Huhtikuuta 2025
8 Huhtikuuta 2025
7 Huhtikuuta 2025
4 Huhtikuuta 2025
4 Huhtikuuta 2025
2 Huhtikuuta 2025
1 Huhtikuuta 2025
30 Maaliskuuta 2025
30 Maaliskuuta 2025