GE JX7227FMDS Käyttöohje

Sivut 8 Engels Magnetron

Lue käyttöohje merkille GE JX7227FMDS ilmaiseksi verkossa tai lataa PDF. Ohje on ollut hyödyllinen 43 henkilölle. Kysyttävää mallista? Esitä kysymys

PartQuantity
Trim Frame1
Screw Covers4
Base Pan1
Upper Bracket1
Rail2
Bottom
Bracket
2
Head Screws
24
(19 required
for installation)
Head Flat-
tipped Screws
6
(4 required for
installation)
PARTS INCLUDED
Questions? Call GE Answer Center at 800.626.2000 orVisit our Website at:
www.GEAppliances.com
READ CAREFULLY.
KEEP THESE INSTRUCTIONS
.
Installation Built-In Trim Kits
Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT –Save these
instructions for local inspector’s use.
•
IMPORTANT –Observe all
governing codes and ordinances.
• Be sure to leave these Note to Installer –
instructions with the Consumer.
• Keep these instructions Note to Consumer –
for future reference.
• For easier installation and personal safety, we
recommend that two people install this microwave oven.
• Unplug the microwave oven before attempting
installation of this kit.
• Skill level– Installation of this appliance requires
basic mechanical and electrical skills.
• Completion time– 1-3 hours
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• This kit and microwave are approved for installation
alone or above any single electric wall oven. Do not
mount adjacent (within 2 feet) to any range, cooktop,
gas oven, or other microwave.
TOOLS YOU WILL NEED
#2 Phillips
screwdriver
Pencil
Tape measure
Level
Small flathead
screwdriver
Drill with
7
»64” bit or #35
1
FOR YOUR SAFETY
WARNING
Before beginning the installation,
switch power off at service panel and lock the
service disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to
the service panel.
WARNING
This oven must be plugged into a
properly grounded 3-hole, 120 volt receptacle as
required by the National Electric Code.
MODELS
30” Profile Kit: JX7230DLWW, JX7230DLBB,
JX7230ELES, JX7230SLSS, JX7230BLTS
27” Profile Kit: JX7227DLWW, JX7227DLBB,
JX7227ELES, JX7227SLSS, JX7227BLTS
Monogram Kit: ZX2130SLSS, ZX2127SLSS

Arvostele tämä ohje

Tuotetiedot

Merkki: GE
Kategoria: Magnetron
Malli: JX7227FMDS

Tarvitsetko apua?

Jos tarvitset apua merkille GE JX7227FMDS esitä kysymys alla ja muut käyttäjät vastaavat sinulle