GE FPDW1 Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille GE FPDW1 (4 sivua) kategoriassa Kuivausrumpu. Tämä opas oli hyödyllinen 56 henkilölle ja sai 4.9 tähden keskimäärin 5 käyttäjältä

134176300B11/03

IMPORTANT: Read and save these instructions.

Washer & Dryer Pedestal Kit

NOTICE! This kit is intended to be installed by persons having electrical and mechanical training and a

level of knowledge considered acceptable in the appliance repair trade.

Your safety and the safety of others are very

important. Many important safety messages are

provided in these instructions and on your

appliance. Always read and obey all safety

messages.

WARNING

EXCESSIVE WEIGHT HAZARD

Two or more people may be required to move and

install the washer & dryer with pedestals.

Failure to comply may cause back or other injury.

Tools needed:

Level

9/16” open end wrench or ratchet

Channel-lock adjustable pliers

2# Phillips screwdriver

Flat blade screwdriver

WASHER INSTALLATION

Washer Hardware

1.Remove the 24-3/8” x 27” x 12”pedestal,

installation hardware and instructions from the

shipping carton.

2.Using the pedestal shipping carton for

protection, carefully lay the washer on its back.

NOTE: If washer was previously installed,

disconnect from power supply, remove inlet

hoses from water faucets and tape the drain hose

to the top front of the washer to eliminate excess

water on the floor.

3.Remove the four (4) leveling legs from the

washer base and discard.

4.If the washer has rollers, remove the four (4)

screws securing the rollers to the base.

5.Install the four (4) leveling legs (supplied with

the kit) fully into the pedestal.

6.The words “TOP FRONT” are embossed on the

top front of the pedestal. Position the pedestal so

the words are up with the front of the washer.

Align the pedestal mounting holes with the

threaded leg holes on the washer base.

Tuotetiedot