Extron XPA 4002 Käyttöohje
Sivut 2 Engels Vastaanotin
Lue käyttöohje merkille Extron XPA 4002 ilmaiseksi verkossa tai lataa PDF. Ohje on ollut hyödyllinen 42 henkilölle. Kysyttävää mallista? Esitä kysymys
1
Product Category
XTRA™ Full Rack Series • Setup Guide
This guide provides basic instructions for an experienced installer to set up and operate the Extron XTRA Full Rack Series of
power amplifiers. All user guide references refer to the .XTRA Full Rack Series User Guide
• XPA 2002 outputs stereo audio at 200 watts rms per channel (4-ohm speakers) or 100 watts rms per channel (8-ohm
speakers) on channels 1 and 2. Output is 400 watts bridged mono (8-ohm speaker).
• XPA 2002-70V outputs 200 watts rms per channel on channels 1 and 2 for 70 V systems.
• XPA 2002-100V outputs 200 watts rms per channel on channels 1 and 2 for 100 V systems.
• XPA 2003C-70V outputs 200 watts per channel (4-ohm speakers) or 100 watts per channel (8-ohm speakers) on channels
1 and 2, and 200 watts (70 V line, mono) on channel 3.
• XPA 2003C-100V outputs 200 watts per channel (4-ohm speakers) or 100 watts per channel (8-ohm speakers) on
channels 1 and 2, and 200 watts (100 V line, mono) on channel 3.
• XPA 2004 outputs stereo audio at 200 watts per channel (4-ohm speakers) or 100 watts per channel (8-ohm speakers) on
channels 1, 2, 3, and 4. Output is 400 watts per bridge in bridged mono (8-ohm speakers) on bridge A (channels 1 and
2) and bridge B (channels 3 and 4).
• XPA 4002 outputs stereo audio at 400 watts rms per channel (4-ohm speakers) or 200 watts rms per channel (8-ohm
speakers) on channels 1 and 2. Output is 800 watts bridged mono (8-ohm speaker).
• XPA 4002-70V outputs 400 watts rms per channel on channels 1 and 2 for 70 V systems.
Installation
1. Power off — Turn off all equipment including the XPA amplifier by toggling the power off and disconnecting the
power cord. Verify that the amplifier is disconnected from the power source before proceeding.
2. Mount the amplifier — For diagrams of typical application examples, see the “Application Examples” section in the user
guide. For further mounting instructions, see the “Mounting the XTRA Series of Power Amplifiers” section in the user
guide.
3. Wire the input — Wire the input to the 3.5 mm input connectors of the amplifier, as shown in the following illustraion. t
See the “Rear Panel Features and Operation” section in the user guide for bridging information.
NOTE:Control signal ground pins may be labeled as or “G”. Audio ground pins may be labeled as or .
The wiring and function are the same, whichever way your product is labeled.
NOTE: The wires : tinned wire does not hold tight in the captive screws and can break easily must not be tinned
after several bends.
4. Wire the outputs — Wire speakers to the output connectors of the amplifier using the included 2-pole (70 V or 100 V)
or 4-pole (8 ohm or 4 ohm) screw lock plug.
2-pole (70 V or 100 V) output connector wiring: 4-pole (8 ohm or 4 ohm) output connector wiring:
CAUTION:Do not short the “” and “” outputs to each other. Doing so may damage the amplifier.+
For complete wiring details, see “Rear Panel Features and Operation” in the user guide.
12
(BRIDGE)
Do not tin the wires!
OUTPUT
70V
" (5 mm) MAX.
Tip
Sleeve
Ring
Tip
Sleeve
Unbalanced Input
Balanced Input
1
12
Do not tin the wires!
12
OUTPUT
Tuotetiedot
| Merkki: | Extron |
| Kategoria: | Vastaanotin |
| Malli: | XPA 4002 |
Tarvitsetko apua?
Jos tarvitset apua merkille Extron XPA 4002 esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Vastaanotin Extron Käyttöohjeet
Extron MPA 152 Plus Käyttöohje Extron DTP3 R 201 Käyttöohje Extron DTP R HWP 4K 331 D Käyttöohje Extron NetPA U 8001 SUB Käyttöohje Extron NetPA 1001-70V AT Käyttöohje Extron XPA U 4004 FX Käyttöohje Extron XTRA XPA 2001 Käyttöohje Extron MDA 5A RCA Käyttöohje
Kaikki Extron Vastaanotin käyttöohjeet
Suosittuja kategoriassa Vastaanotin
Vastaanotin Käyttöohjeet
Viimeisimmät Vastaanotin Käyttöohjeet
SoundTube MA501T Käyttöohje SoundTube SB335 Käyttöohje SoundTube SA502 Käyttöohje SoundTube SA202-II Käyttöohje SoundTube WLL-TR-1p-II Käyttöohje SoundTube WLL-RX1p-II Käyttöohje Clare Controls amp.7150 Käyttöohje Clare Controls amp.1640 Käyttöohje Edwards Signaling 5532M Käyttöohje Phoenix Gold ZQ5004 Käyttöohje