Danfoss VLT MCD 202 Käyttöohje

Danfoss Ei luokiteltu VLT MCD 202

Lue alta 📖 käyttöohje suomeksi merkille Danfoss VLT MCD 202 (12 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 26 henkilölle ja sai 4.2 tähden keskimäärin 13.5 käyttäjältä

Sivu 1/12
MCD Modbus Module Instructions Important User Information
MG17F702 - VLT
®
is a registered Danfoss trademark 1
INSTALLATION INSTRUCTIONS: MCD MODBUS MODULE
Order Code: 175G9000
1. Important User Information
Observe all necessary safety precautions when controlling the soft starter remotely. Alert
personnel that machinery may start without warning.
It is the installer's responsibility to follow all instructions in this manual and to follow correct
electrical practice.
Use all internationally recognised standard practice for RS-485 communications when installing
and using this equipment.
2. Installation
CAUTION
Remove mains and control voltage from the soft starter before attaching or removing
accessories. Failure to do so may damage the equipment.
2.1. Installation Procedure
1. Remove control power and mains supply from the soft starter.
2. Attach the Modbus Module to the starter as shown.
3. Apply control power to the soft starter.
2.2. Physical installation
1. Fully pull out the top and bottom retaining clips on the module.
2. Line up the module with the comms port slot.
3. Push in the top and bottom retaining clips to secure the module to the starter.
177HA528.11
Remove the MCD Modbus Module using the following
procedure:
1. Take the module off-line.
2. Remove control power and mains supply from the
soft starter.
3. Disconnect all field wiring from the module.
4. Fully pull out the top and bottom retaining clips on
the module.
5. Pull the module away from the soft starter.
177HA378.11

Tuotetiedot

Merkki: Danfoss
Kategoria: Ei luokiteltu
Malli: VLT MCD 202

Tarvitsetko apua?

Jos tarvitset apua merkille Danfoss VLT MCD 202 esitä kysymys alla ja muut käyttäjät vastaavat sinulle