AXESS AXDCT-2 Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille AXESS AXDCT-2 (3 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 25 henkilölle ja sai 4.4 tähden keskimäärin 13 käyttäjältä

Sivu 1/3
AXDCT-2
INSTALL ATION INSTRUCT IONS
REV. 3/2/20
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
Integrate • AxxessInterfaces.com
The AXDCT-2 should be installed on a stereo’s speaker output wires or the
output wires on an factory amplifier of up to 80 watts per channel. These
wires can be found behind the stereo in the dash, on the outside of an factory
amplifier, or on the input terminals on the factory speakers.
stereo applications as follows:
Yellow - Battery +12v input †
Black - Ground input †
Blue - Remote +12v output †
These wires can be connected directly to the amplifier being installed.
Wires only required if a 12v amp turn-on is desired.
White - Left front (+) input
White/Black - Left front (-) input
Gray - Right front (+) input
Gray/Black - Right front (-) input
Black/White - Reference ground (-)
(Reference ground optional if noise is present)
Note: Be sure that all audio input connections are polarized or in phase with
each other. That is, the positive output wires from the audio source need to be
connected to the corresponding positive input wires of the AXDCT-2. The same
goes for the negative audio wires. Failure to do this will result in poor bass
response and low quality audio.

Tuotetiedot

Merkki: AXESS
Kategoria: Ei luokiteltu
Malli: AXDCT-2

Tarvitsetko apua?

Jos tarvitset apua merkille AXESS AXDCT-2 esitä kysymys alla ja muut käyttäjät vastaavat sinulle