AXESS AX-ADXSVI-AU1 Käyttöohje

AXESS Ei luokiteltu AX-ADXSVI-AU1

Lue alta 📖 käyttöohje suomeksi merkille AXESS AX-ADXSVI-AU1 (4 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 40 henkilölle ja sai 4.9 tähden keskimäärin 20.5 käyttäjältä

Sivu 1/4
METRA. The World’s best kits.™ metraonline.com1-800-221-0932
© COPYRIGHT 2004-2014 METRA ELECTRONICS CORPORATION
Installation Instructions for AX-ADXSVI-AU1
REV. 9/26/2014 INSTAX-ADXSVI-AU1
(continued on next page)
AX-ADXSVI-AU1
Audi CAN interface 2006-2013
Caution: Metra recommends disconnecting the negative battery terminal before
beginning any installation. All accessories, switches, and especially air bag indicator
lights must be plugged in before reconnecting the battery or cycling the ignition.
*Note: Refer also to the instructions included with the aftermarket radio.
AUDI
A3* 2006-2013
A4/RS 4/S4 w/ NAV 2005-2008
A4/RS 4/S4 2007-2008
A4/RS 4/S4* 2006
TT 2008-2013
*Note: Only for models with either a
Symphony Plus or NAV radio.
APPLICATIONS
FEATURES
Note: This harness must be used in conjunction with the AX-ADXSVI.
• Providesaccessory(12-volt10-amp)
• RetainsR.A.P.(retainedaccessorypower)
• ProvidesNAVoutputs(parkingbrake,reverse,andspeedsense)
• PrewiredASWC-1harness(ASWC-1soldseparately)
• Retainsbalanceandfade
• Micro“B”USBupdatable
Connections to be made
From the XSVI-AU1 harness to the aftermarket radio
(a) From the 12-pin harness:
• ConnecttheRedwiretotheaccessorywire.
• ConnecttheOrangewiretotheilluminationwire,iftheaftermarketradiohas
noilluminationwire,tapeofftheOrangewire.
• ConnecttheBlue/Whitewiretotheampturnonwire(thiswiremustbe
connectedtohearsoundfromthefactoryamplifier).
Note: There is a Blue wire on the 40-pin harness to connect as well.
Thefollowingwiresareforaftermarketmultimedia/navigationradiosthatprovide
thesewires(ifnotrequired,tapethemoffanddisregardthem):
• ConnecttheLight Greenwiretotheparkingbrakewire(ifapplicable).
• ConnecttheGreen/Purplewiretothereversewire(ifapplicable).
• TheBlue/Pinkwirewillnotbeused,tapeitoffanddisregardit.
Note: This wire will be on the 40-pin harness instead.
(b) From the 40-pin harness:
• ConnecttheBlackandBlack/Whitewirestothegroundwire.
• ConnecttheYellow wiretothebatterywire.
• ConnecttheBluewiretotheampturnonwire(thiswiremustbeconnected
tohearsoundfromthefactoryamplifier).
Thefollowingwireisforanaftermarketmultimedia/navigationradiothat
providesthiswire,ifnotrequired,tapeitoffanddisregardit:
• ConnecttheBlue/Pinkwiretothespeedsensewire(V.S.S.),ifapplicable.
INTERFACE COMPONENTS
•XSVI-AU1harness
TOOLS REQUIRED
•Cuttingtool•Tape•Crimpingtool
•Connectors(i.e.butt-connectors,bellcaps,etc.)

Tuotetiedot

Merkki: AXESS
Kategoria: Ei luokiteltu
Malli: AX-ADXSVI-AU1

Tarvitsetko apua?

Jos tarvitset apua merkille AXESS AX-ADXSVI-AU1 esitä kysymys alla ja muut käyttäjät vastaavat sinulle