AFX Boon BONP2032L30D1BK Käyttöohje
Lue alta 📖 käyttöohje suomeksi merkille AFX Boon BONP2032L30D1BK (2 sivua) kategoriassa Lamppu. Tämä opas oli hyödyllinen 19 henkilölle ja sai 4.8 tähden keskimäärin 10 käyttäjältä
Sivu 1/2
LED r Luminaires Indoo
Pendant Ceiling Mount
120V / 60HzAC
Page 1 of 1 R1 8060417
Model #: BONP2032L30D1BK
Model #: BONP2032L30D1WH
Limited Factory Warranty
AFX Inc. hereby warranty that this xture is free from defects in materials and workmanship when installed and used under normal operating
conditions for a period of 5 years from date of shipment from factory. This warranty covers all component parts and extends only to replacement of
defective xture or components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.
Safety Precautions
Read all safety precautions and installation instructions carefully before installing or servicing this xture. Failure to comply with these instructions
could result in potentially fatal electric shock and/or property damage.
It is recommended that a qualied electrician perform all wiring. This xture must be wired in accordance with all national and local electrical codes.
Do not handle any energized xture or attempt to energize any xture with wet hands or while standing on a wet or damp surface or in water.
This xture is designed for use in a 120VAC, 60Hz fused circuit only. This xture is compatible with a TRIAC (forward-phase or leading-edge) / ELV
(reverse-phase or trailing- edge).
To reduce the risk of electrical shock, and to assure proper operation, this xture must be adequately grounded. To accomplish proper grounding,
there must be a separate ground wire (green) contact between this xture and the ground connection of your main power supply panel.
This xture is intended to be used for general indoor lighting in dry or damp locations.
Disclaimer
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and
Canadian ICES-005 (B) / NMB-005 (B). These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiver antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult with the dealer or an experienced radio/TV technician for help.
Any modications to this xture may void the warranty and interfere with the safe operation of the luminaire.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device
Assembly Instructions
Step 1 Preparing for installation–
A. at fuse or circuit breaker box before installing or servicing any part of this xture. Disconnect electrical power
B. Carefully remove the xture from the carton, remove components from hardware kit.
C. Install mounting bracket (1) to the junction box (not included) using two screws to (2) secure it.
Wiring All wiring must take place inside junction box (not included) –
Caution: Make sure power is o at fuse or circuit breaker box. Check power wires for damage or scrapes. If power
supply wires are within three inches of the LED driver, use wire suitable for at least 90°C (194°F). Most Note:
dwellings built before 1985 have supply wire rated to 60°C. Consult a qualied electrician to ensure correct branch
circuit conductor before installing.
Step 2 Wiring xture –
A. Make all wire connections to appropriate wire. Secure with wire nuts (provided).
B. Connect the green wire from the xture to the supply power source ground wire.
C. Connect the white wire from the xture to the white (N) wire from supply power source. For none-dimming xture.
Connect the black xture wire to the black (L) wire from supply power source.
D. Connect the white wire from the xture to the white (N) wire from dimming source per dimmer For TRIAC dimming.
wiring instructions. Connect the black wire from the xture to the black (L) wire from dimmer supply power source per
dimmer wiring instructions.
E. Pull on each wire lead to make sure connections are secure. Make certain no bare wires are Do not mix wires.
exposed outside of wire connectors. Tuck all connections neatly into the junction bo x.
Step 3 Mounting fixture –
A. Adjust cord length by loosening the strain relief screws on the bottom of the canopy (4). Pull the cord through the top
of the canopy and re-tighten the screw once the xture is at the desired height. Repeat for all strain reliefs.
B. Place xture canopy (4) over the xture mounting plate (1), aligning the side holes (5). Then use two screws (3) to
secure the xture in place.
Step 4 Restore power at fuse or circuit breaker box –
Tuotetiedot
| Merkki: | AFX |
| Kategoria: | Lamppu |
| Malli: | Boon BONP2032L30D1BK |
Tarvitsetko apua?
Jos tarvitset apua merkille AFX Boon BONP2032L30D1BK esitä kysymys alla ja muut käyttäjät vastaavat sinulle
Lamppu AFX Käyttöohjeet
1 Tammikuuta 2025
15 Lokakuuta 2024
15 Lokakuuta 2024
15 Lokakuuta 2024
15 Lokakuuta 2024
Lamppu Käyttöohjeet
- Lamppu Livex Lighting
- Lamppu Currey & Company
- Lamppu Lucide
- Lamppu Elgato
- Lamppu NEO Tools
- Lamppu Rotolight
- Lamppu Zhiyun
- Lamppu Theben
- Lamppu Trust
- Lamppu Integral LED
- Lamppu Maginon
- Lamppu Impact
- Lamppu Trio Lighting
- Lamppu Karma
- Lamppu Nedis
Viimeisimmät Lamppu Käyttöohjeet
8 Huhtikuuta 2025
8 Huhtikuuta 2025
5 Huhtikuuta 2025
5 Huhtikuuta 2025
5 Huhtikuuta 2025
4 Huhtikuuta 2025
4 Huhtikuuta 2025
4 Huhtikuuta 2025
4 Huhtikuuta 2025
4 Huhtikuuta 2025