Advanced Network Devices IPSCM-RMe Käyttöohje

Lue alta 📖 käyttöohje suomeksi merkille Advanced Network Devices IPSCM-RMe (2 sivua) kategoriassa Ei luokiteltu. Tämä opas oli hyödyllinen 24 henkilölle ja sai 3.6 tähden keskimäärin 12.5 käyttäjältä

Sivu 1/2
Round Ceiling IP Speaker (Mic Enabled)
(IPS -RMe) Installation CM
Advanced Network Devices 3820 Ventura Dr. Arlington Hts. IL 60004
tech@anetd.com www.anetd.com/ - - 847 463 2237 •
1 v1.2
INSTALLATION
The device ships with a ferrite for optional
usage. For any concerns over line
cable around ferrite once and clamp shut.
IPSCM- - ASSEMBLY FOR RM CB
SUSPENDED CEILINGS
1. A gn the IPSCM-li RM-CB bridge on the
tile, such that the support legs end at
the tile edges, and mark along the round
section; rotate bridge 90˚ to mark
remainder of hole. Use caution when
handling the bridge as it contains sharp
edges.
2. Cut ceiling tile along the marked circle.
3. Place the IP speaker assembly on flat
surface, magnet side up.
4. Center ceiling tile over the IPSCM-RMe
speaker.
5. Place the IPSCM- -CB bridge over the RM
baffle assembly with two studs of the
speaker baffle running through the two
small oval holes of the bridge.
6. Secure speaker assembly, tile, and
IPSCM- -CB bridge together with RM
the two #8-32 nuts provided in the
bag attached to the speaker magnet.
7. Complete the network cable run to
the speaker. IP
8. Install back box (IPSCM- -BB) if RM
necessary, per instructions in next
section.
9. Connect the network cable to
Ethernet jack labeled PoE/PoE+.
10. Secure IPSCM-RM-BB back box if
used, tie off unit to building structure
if required using straps on the back
box, then place entire assembly into
ceiling.

Tuotetiedot

Merkki: Advanced Network Devices
Kategoria: Ei luokiteltu
Malli: IPSCM-RMe

Tarvitsetko apua?

Jos tarvitset apua merkille Advanced Network Devices IPSCM-RMe esitä kysymys alla ja muut käyttäjät vastaavat sinulle